Az oldal jelenleg ZÁRVA van!
Kérem próbálkozzon újra egy későbbi időpontban.
Hírlevél
TOP termékek
Termékajánló
Tanúsítvány
SSL Certificate
Termék részletek


A254 MicroSD card breakout board

A254 MicroSD card breakout board
3 480 Ft

Not just a simple breakout board, this microSD adapter goes the extra mile - designed for ease of use.

    • Onboard 5v->3v regulator provides 150mA for power-hungry cards
    • 3v level shifting means you can use this with ease on either 3v or 5v systems
    • Uses a proper level shifting chip, not resistors: less problems, and faster read/write access
    • Use 3 or 4 digital pins to read and write 2Gb+ of storage!
    • Activity LED lights up when the SD card is being read or written
    • Four #2 mounting holes
    • Push-push socket with card slightly over the edge of the PCB so its easy to insert and remove
    • Comes with 0.1" header (unattached) so you can get it on a breadboard or use wires - your choice
    • Tested and assembled here at the Adafruit factory
    • Works great with Arduino, with tons of example code and wiring diagrams

    To use with an Arduino, connect GND to ground, 5V to 5V, CLK to pin 13, DO to pin 12, DI to pin 11, and CS to pin 10. Then you can use the Arduino IDE's SD library which supports FAT and FAT32 SD cards. For details on getting started, check out our detailed tutorial, it discusses microSD cards, wiring and how to use this breakout board with an Arduino or CircuitPython

  • Brand
    Adafruit
    Típus
    Others
    Összeszerelést Igényel
    Nem
    Állapot
    Új
    Cikkszám
    A254